Bell Boots – Tips on how to Use Them on Your Horses

Bell boots are a horse’s first line of protection towards their own sharp back feet. They wrap across the front hoofs and cover the vulnerable coronary band and heel bulbs, which are essential for preventing lacerations to those sensitive areas.

We regularly use bell boots when training our horses or for these prone to overreaching and injuring themselves. But not all horses need bell boots.

What’s the purpose of bell boots for horses?

Bell boots are protective equipment that attaches to the horse’s front feet. The bell boot serves purposes for equestrians: it protects their horses’ from injury and prevents their back toes from hitting the horseshoes on their entrance feet and pulling them off.

When they run, some horses tend to overreach and strike the front of their rear hoofs into the back of their front feet. The soft areas at the heel bulb and coronary band are most susceptible to injury from this hitting.

What do bell boots protect?

The common area damaged is the heel bulb, coronary band, and lower pastern. Generally an overreach injury might be extreme and cause everlasting damage.

Heel bulbs are the region that the majority often gets injured by overreaching. The heel bulb is the fleshy part of the rear part of a horse’s foot – proper above their hairline and below their pasterns.

A horse’s rear hoof can strike the heel bulb with such a force that it cuts by means of flesh and severely injure your horse, inflicting pain, swelling, and profuse bleeding. In some cases, horses develop lengthy-lasting problems and lameness.

The most critical injuries occur when a horse strikes into the back of its pastern. Higher up overreach accidents on the back of their leg might also find yourself with them in surgery resulting from lacerating tendons or going into tendon sheath just above the fetlock area.

How do horses wear bell boots?

There are two main types of bell boots, pull-on and open bell boots with velcro closures. Pull-on boots are typically made of rubber and slide over your horse’s foot. They’re easy to clean and nice for horses who want boots throughout turn-out and often get their feet wet.

Fitting pull-on bell boots

Pull-on bell boots shouldn’t fit cosy in your horse’s pastern but relatively be loose. If they’re tight, they’ll irritate the horse skin and rub it raw. To assist prevent chafing, some bell boots are fleece lined, which is sweet however fitting your boots accurately is still important.

Ideally, you should be able to fit a finger between the top of the bell boot and your horse’s lower leg. However it’s best to only be able to fit one finger because if the boots are too massive, they will slide off your horse’s foot. When your horse is standing on a flat surface, the back of the boot should nearly contact the ground.

Most bell boots come in four sizes: small, medium, giant, and extra-large. Typically Arabians and Quarter horses use medium, Thoroughbreds massive, and further-massive fit Warmbloods. There may be lots of variation in manufacturer sizing, so it’s greatest to be safe and read opinions before buying.

Putting pull-on bell boots on your horse.

Putting pull-on bell boots on your horse isn’t always straightforward and takes some practice. First, flip the bell boot inside out. Then lift your horse’s foot and put the bell boot on, starting on the bottom of it.

As you set it on, pull hard to stretch it, work your way as much as where it is smaller, and then tug on it until you’ll be able to fit your horse’s hoof through. As soon as it’s on, flip it down, and the boot is ready.

Versatile bell boots that stretch easily work greatest to get the most effective fit and are simpler to get over the horse’s hoof.

Putting on open bell boots

Placing on open bell boots in your horse is easy. You just wrap them around the horse’s hoof and then safe them with velcro straps. Some have a hook-and-loop closure so you possibly can adjust to fit different size feet.

Bell boots designed with velcro straps are typically more expensive, but they save you time getting them on and off, and most are made of sturdier materials than their pull-on counterparts.

How do you know in case your horse wants bell boots?

A simple way to know in case your horse would benefit from wearing bell boots is if they come back from working with scrapes or swelling on its heels. One other thing to look for is that if they’re consistently losing shoes or often have loose shoes.

Bell boots help protect the shoes on your horse’s entrance feet from being pulled off once they’re hit by their back foot. This is widespread among some horses which have been turned out to play or ones running fast, but it can occur throughout other activities too!

Leave a Reply

Your email address will not be published. Required fields are marked *